Sherwood NEWCASTLE R-945 Operating Instructions Manual page 13

Memorize the desired subwoofer mode
while it flickers.
MEMO} ENTER
the above step 2.
Checking the speaker setting
SPEAKER
MOOE
co
« Each time this button is pressed briefly, the setting
of the center speaker, the rear speakers or the
subwoofer is displayed.
Press the TEST TONE button to adjust the
volume level of each speaker.
¢ Test tone will be heard form each speaker for 2
seconds each as follows;
C FRONT L-> CENTER-FRONT R->REAR R-REAR L-*SUB "|
¢ The test tone will be heard from the subwoofer only
when subwoofer is set to "YES" in the DTS mode
and the Dolby Digital(AC-3) mode.
+ Test tone is not heard from rear speakers in Dolby 3
Stereo mode.
« Test tone is not heard from the speaker of which the
setting is adjusted to the NONE or the NO mode.
Adjust the volume levels of the speakers
until they all sound equally loud.
* The rear L and R volume levels are adjusted
respectively during the test tone function and all
together while enjoying surround sounds.
Cancel the test tone function.
¢ The delay time will be displayed for 5 seconds.
¢ In Dolby Digital(AC-3) mode, the correspondng
delay time will be flickering.
* The center delay time can be adjustable only in Dolby
Digital(AC-3) mode.
* The rear delay time can be adjustable only in Dolby
Digital(AC-3) and Dolby Pro Logic modes.