Table of Contents
Advertisement
CONTROLS
Setting the compass zones
Sets the particular compass zones on the vehicle
so that the compass operates correctly; refer to
World map with compass zones.
World map with magnetic zones
Procedure
1.
Press and hold the control button for approx.
3 to 4 seconds. The number of the set com‐
pass zone appears in the mirror.
2.
To change the zone setting, press the control
button quickly and repeatedly until the num‐
ber of the compass zone that corresponds
with your location appears in the mirror.
The set zone is stored automatically. The com‐
pass is ready for use again after approximately
10 seconds.
Calibrating the digital compass
The digital compass must be calibrated in the
event of the following:
▷
The wrong compass point is displayed.
184
Interior equipment
Online Edition for Part no. 01402989267 - II/18
▷
The point of the compass displayed does not
change despite changing the direction of
travel.
▷
Not all points of the compass are displayed.
Procedure
1.
Make sure that there are no large metallic ob‐
jects or overhead power lines near the vehicle
and that there is sufficient room to drive
around in a circle.
2.
Set the currently applicable compass zone.
3.
Press and hold the control button for approx.
6 to 7 seconds so that "C" appears on the
display. Next, drive in a complete circle at
least once at a speed of no more than
4 mph/7 km/h. If calibration is successful, the
"C" is replaced by the points of the compass.
Advertisement
Table of Contents
