Blank Skip Function; Repeat Play - Clarion ARX9470R Owner's Manual

Tape Operations
Dolby noise reduction system
The dolby noise reduction system increases the
volume level of high frequency sounds during
recording and sets it back to their original level
during play. This system reduces hissing noise
which is typical of cassette tapes.
_+& Dolby noise reduction manufactured under license
from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
1. Each time you press Dolby NR button [9], the
mode changes among B NR ON, C NR ON,
and Dolby NR OFF.
2. When B NR ON or C NR ON is set, "B NR" or
"C NR' lights in the display respectively. When
Dolby NR OFF is set, both "B NR" and "C NR"
go off from the display. Select the same mode
as when the tape was recorded.
Scan play
Scan play allows the first 10 seconds of all the
tracks on the cassette tape to be played.
1. Press SCN button [7]. "SCN" lights in the dis-
play.
2. To cancel the scan play, press SCN button
again. "SCN" goes off from the display.
** When the tape is fast-forwarded in the scan
play, "SCN" appears in the display.
* When the end of the tape is reached during
the scan play and the tape is switched to the
other side, the scan play continues on that side.
* If you select other function mode during the
scan play, the tape stops at the beginning of
the next track (APC function).
Repeat play
The repeat function allows a selected track to be
played repeatedly.
1. Press RPT button [8]. "RPT" lights in the dis-
play.
2. To cancel repeat play, press RPT button [8]
again. "RPT" goes off from the display and the
normal play resumes.
* While the tape is being rewinded in the repeat
play, "RPT" appears in the display.
20 ARX9470R/ARX9470RW
Blank skip function
The blank skip function allows the play to be
. skipped to the beginning of the next recorded
track when there is a blank section of 12 sec-
onds or longer on the tape.
1. Press and hold BLS button [8! for 2 seconds
or longer. "BLS" lights in the display.
2. To cancel blank skip, press and: hold BLS but-
ton [8] again for 2 seconds or longer. "BLS"
goes off from the display and the normal play
resumes.
* While the tape is being fast-forwarded in the
blank skip, "BLS" appears in the display.
Notes:
The APC, Scan play, Repeat play, Blank skip may
not work properly with tapes of the following quali-
ties:
e Tapes on which the recording level is too low.
° Tapes on which there is much noise between se-
lections.
© Tapes on which there are long pauses in the middle
of selections.
© Tapes on which there are less than 4 seconds of
blank space between selections.