Assembly - Westinghouse WGen9500DF User Manual

ASSEMBLY

CARTON CONTENTS
CAUTION
sistance when lifting the generator.
l Carefully open the carton.
l Remove and save the carton contents.
l Remove and discard the packing tray.
l Unfold the top of the plastic bag enclosing the generator.
l Carefully cut the vertical corners of the carton to access
the generator.
l Recycle or dispose of the packaging materials properly.
INCLUDED LIST
User manual
Quick Start Guide/Maintenance Schedule
LPG/propane hose with regulator
Remote start key fob (attached to recoil starter)
1.16 quart (1.1 Liter) bottle of SAE 10W-30 Oil
Battery charger
Spark plug socket wrench
Oil funnel
Assembly wrench
Mounting foot (2)
Flange bolt, M8 (4)
Wheel (2)
Axle (2)
Washer (2)
Cotter pin (2)
If any parts are missing, contact our service team at
service@wpowereq.com or call 1-855-944-3571.
INSTALL FEET AND WHEELS
See Figures 8 - 9
NOTICE
Assembling the generator will require
lifting the unit on one side. Install the mounting feet
and wheel before adding fuel or oil.
l Place generator on a flat surface.
l Tip the generator on a piece of cardboard or other soft
material to protect the frame paint and prevent the gen-
erator from sliding.
l With the included wrench, install the mounting feet to the
frame as shown.
l Install the wheels as shown.
NOTE: The wheels are only intended for hand transport.
The wheels are not suitable for towing the generator either
on- or off-road.
Weight hazard. Always have as-
FIG. 8
A
B
A - Mounting foot
B - Bolt
FIG. 9
D
D
A - Axle
B - Wheel
C - Washer
D - Hitch pin
FIG. 10
A - Quick-connect plug
CONNECT THE BATTERY
See Figure 10.
A quick-connect battery plug is pre-installed on the battery.
Remove the cable tie securing the plugs then push firmly
to connect them.
NOTE: The generator is equipped with a battery charging
feature. Once the engine is running, a small charge will
slowly recharge the battery.
C
A
B
A
English | 13