Westinghouse WGen9500DF User Manual page 18

OPERATION
DATA CENTER
See Figure 16.
Push the mode button to cycle through the data display
modes.
Voltage: Displays current voltage output.
Frequency (Hz): Displays power output frequency in Hertz.
Lifetime Hours: Displays the lifetime run hours.
Run Time/Maintenance: Displays current run time. Resets
to zero when shut down. Maintenance reminder displayed
when required.
Maintenance Codes:
P25 – Change engine oil
P50 – Clean air filter, Change engine oil
P100 – Change engine oil, clean air filter, replace fuel filter
SELECTING THE FUEL SOURCE
See Figure 17.
DANGER
NOT add gasoline to the fuel tank or connect the LPG/
propane hose to the generator while the generator is
in operation.
NOTICE
Do not overload the generator. Load
capacities differ depending on the fuel source. Before
switching fuel sources, make sure the generator can
supply enough running (continuous) and peak (start-
ing) watts for the items your connected items.
The fuel source can be switched while the engine is off
or while it is running if a propane tank is connected to the
generator BEFORE operation. If you switch from gasoline
to another fuel source while the engine is running, it may
run rough for a few seconds as it purges gasoline from the
carburetor.
To switch to gasoline:
l Turn the fuel valve to the open position to start the flow
of gasoline.
l Rotate the fuel selector switch fully clockwise for
GASOLINE.
l Turn off the flow of propane gas.
To switch to propane:
l Open the cylinder valve on the LP gas cylinder to start
the flow of propane.
l Rotate the fuel selector switch fully counterclockwise for
PROPANE.
l Turn off the flow of gasoline.
18 | English
DATA CENTER
DATA CENTER
Voltage:
Voltage:
Displays current voltage
Displays current voltage
output.
output.
Fire and explosion hazard. DO
METER V-F-T
METER V-F-T
Push the Mode button to cycle through
the data display modes.
FIG. 16
DATA CENTER
A
Voltage:
C
Displays current voltage
output.
METER V-F-T
Frequency (Hz):
Lifetime Hours:
Frequency (Hz):
A - Voltage
Displays power output
Displays the lifetime run
Displays power output
frequency in Hertz. B - Power output
hours.
frequency in Hertz.
C - Lifetime hours
D - Run time/maintenance reminder
Push the Mode button to cycle through
E - Mode button
the data display modes.
FIG. 17
A
A - Propane
B - Gasoline
C - Fuel selector switch
HIGH ALTITUDE OPERATION
Engine power is reduced the higher you operate above sea
level. Output will be reduced approximately 3.5% for every
1,000 feet of increased altitude from sea level.
High altitude adjustment is required for operation at altitudes
over 5,000 ft. (1524 m). Operation without this adjustment
will cause decreased performance, increased fuel consump-
tion, and increased emissions.
NOTICE
tudes below 2,000 ft. (762 m) with the high altitude kit
installed. Engine damage may occur.
High Altitude
Carburetor Kit
High Altitude
DF Regulator
NOTE: You must purchase both the Dual Fuel Regulator
and Carburetor Kit for proper high altitude operation.
Voltage:
Displays current voltage
output.
METER V-F-T
DATA CENTER
B
Voltage: Frequency (Hz): Frequency (Hz):
D
Displays current voltage Displays power output Displays power output
output. frequency in Hertz. frequency in Hertz.
METER V-F-T
Push the Mode button to cycle through Push the Mode button to cycle through
Run Time/Maintenance:
Run Time/Maintenance:
Lifetime Hours:
the data display modes. the data display modes.
Displays current run time.
Displays current run time.
Displays the lifetime run
Resets to zero when shut
Resets to zero when shut
hours.
down. Maintenance
down. Maintenance
reminder displayed
reminder displayed
when required.
when required.
Maintenance Codes:
Maintenance Codes:
P25: Change engine oil
P25: Change engine oil
P50: Clean air filter,
P50: Clean air filter,
Change engine oil
Change engine oil
P100: Change engine oil,
P100: Change engine oil,
clean air filter, replace
clean air filter, replace
fuel filter
fuel filter
DO NOT operate the generator at alti-
Part# 518077
Part# 518050-01
Frequency
Displays po
frequency i
Push the Mod
the data disp
E
Lifetime Hours: Lifetime Hours:
Displays the lifetime run Displays the lifet
hours. hours.
B
C