Table of Contents
Advertisement
3-8. Showing and hiding the Grayscale Display Error
If a 6bit (64 color) signal is detected when connecting to the DisplayPort, a grayscale display error can be displayed.
If the error message appears, please turn off the main power, and then turn it on again.
Attention
• Always use with this set to "ON" (the default setting is "ON").
• Set this to "OFF" only when using 6bit (64 grayscale) display.
Procedure
1. Press
to turn off the monitor.
2. Hold down
The "Optional Settings" menu appears.
3. Select "Grayscale Warning" from "Optional Settings", and press
4. Select "On" or "Off" with
5. Select "Finish" with
6. Press
.
The "Optional Settings" menu is closed.
3-9. Enabling/Disabling DDC Communication
The DDC communication can be enabled/disabled. Select the DVI port for DDC communication normally. (This is
different from the DDC/CI communication.)
Procedure
1. Press
to turn off the monitor.
2. Hold down
The "Optional Settings" menu appears.
3. Select "Connection Config." from "Optional Settings", and press
4. Select "DDC", and press
5. Select "Off", "DVI-1", or "DVI-2" with
6. Press
7. Select "Finish" with
8. Press
.
The "Optional Settings" menu is closed.
while pressing
for at least two seconds to turn on the monitor.
or , and press
or .
while pressing
for at least two seconds to turn on the monitor.
.
to exit.
or .
.
or , and press
.
.
.
Chapter3SettingMonitor
31
Advertisement
Table of Contents
