Film Loading - Pentax ZOOM 90-WR Operating Manual

2.
FILM LOADING
Make sure the power is off before inserting the film.
1 Slide the back cover release lever down in the
direction of the arrow to open the back cover as
illustrated.
2 Place the film cartridge in the film chamber by
fitting its flat side on top of the rewind shaft first
and then slide the top end into the camera.
3 Pull the film leader out far enou^ from the
cartridge to reach the take-up sp>ooli^. Align the
tip with the film leader end mark ( lO )®.
Notes:
• Make sure the film is properly placed between the
guide rails O
• If there is dirt on the film detection section^, film
cannot be wound properly.
^ Slack NO ' FJat YES !
• Make sure the film is taut as Illustrated. Take up any slack in the film by pushing it back into the cartridge.
• If the end of the film leader is extremely bent, straighten it or cut off the bent portion.