Hioki 9132-50 Instruction Manual

9132-50
CLAMP ON PROBE
Instruction Manual
July 2015 Revised edition 5
Printed in Japan
9132D981-05 15-07H
Warranty
Warranty malfunctions occurring under conditions of normal use
in conformity with the Instruction Manual and Product Precau-
tionary Markings will be repaired free of charge. This warranty
is valid for a period of one (1) year from the date of purchase.
Please contact the distributor from which you purchased the
product for further information on warranty provisions.
Introduction
Thank you for purchasing the HIOKI Model 9132-50 CLAMP ON
PROBE. To obtain maximum performance from the device,
please read this manual first, and keep it handy for future refer-
ence.
Overview
The 9132-50 are voltage output type clamp on probes, which
are applicable to 1000 A AC current measurements. These
probes can be used to measure alternating current on a live
power line without the need to cut the wire. Easy operation and
connection make them useful for measuring alternating current
and power in various fields.
Inspection and Maintenance
Initial Inspection
When you receive the device, inspect it carefully to ensure that
no damage occurred during shipping. In particular, check the
accessories, panel switches, and connectors. If damage is evi-
dent, or if it fails to operate according to the specifications, con-
tact your dealer or Hioki representative.
Maintenance and Service
• To clean the device, wipe it gently with a soft cloth moistened
with water or mild detergent. Never use solvents such as
benzene, alcohol, acetone, ether, ketones, thinners or gaso-
line, as they can deform and discolor the case.
• Measurements are degraded by dirt on the mating surfaces
of the clamp-on sensor, so keep the surfaces clean by gently
wiping with a soft cloth.
• If the device seems to be malfunctioning, confirm that the
batteries are not discharged, and that the test leads, probes
and fuse are not open circuited before contacting your dealer
or Hioki representative.
Pack the device so that it will not sustain damage during ship-
ping, and include a description of existing damage. We cannot
accept responsibility for damage incurred during shipping.
Safety
This manual contains information and warnings essential for
safe operation of the device and for maintaining it in safe oper-
ating condition. Before using it, be sure to carefully read the fol-
lowing safety precautions.
• This device is designed to comply with IEC
61010 Safety Standards, and has been thor-
oughly tested for safety prior to shipment.
However, mishandling during use could result
in injury or death, as well as damage to the
device. Be certain that you understand the
instructions and precautions in the manual
before use. We disclaim any responsibility for
accidents or injuries not resulting directly from
device defects.
• To avoid short circuits and potentially life-
threatening hazards, never attach the device
to a circuit that operates at more than 600V, or
over bare conductors.
Safety Symbol
Indicates cautions and hazards. When the symbol is
printed on the device, refer to a corresponding topic in the
Instruction Manual.
Indicates that the device may be connected to or discon-
nected from a live circuit.
Indicates a double-insulated device.
Indicates AC (Alternating Current).
T
ta
O
M
T
e
m
m
•
•
T
C
C
C
I
O