Panasonic DoubleFeature PV-D4753S Operating Instructions Manual page 28

The Remote Control can be set to control some TV and
Cable Box/DSS functions.
1
2
Find your TV and Cable Box/DSS Receiver
Brand Code Number on the following page.
• Set up for TV control,
-_ hold down TV button,
-_ enter code with NUMBER keys,
• Set up for Cable or DSS control,
-_ hold down DSS/CABLE button,
÷ enter code with NUMBER keys,
• If code number is 100 or greater,
-_- e.g., press 1 - 0 - 2 for 102.
Confirm code entry,
-_ press POWER to turn selected unit on or off.
• See table below for controllable functions in each mode.
_1 • Repeat setup after remote battery replacement.
• Remote will not control every TV, Cable Box, or
DSS made by the manufacturer listed. If you get
no response, your particular unit cannot be
controlled. There are NO additional codes for the
products listed. If your product is not listed, then
the remote is not compatible with that product.
After remote is set up, you can select VCR, DVD, TV, or
DSS/CABLE for the desired function.
Press VCR, DVD, TV, or DSS/CABLE on the remote.
Table below shows available remote buttons for each mode.)
M_ DVD/VCR TV
DVDNCR All VOL +/-
TV EJECT/OPEN/CLOSE*,
DISPLAY, PLAY, STOP,
FF/SLOW+, REW/SLOW-,
VCR/TV, PAUSE/STILL, SKIP,
AUDIO, CM/ZERO,
CABLE/ TAPE POSITION,
DSS COUNTER RESET, SPEED, VOL +/-
BEC, PAGE
POWER, INPUT,
NUMBER keys,
ENTER,
CHJJV,
VOL +/--
_ POWER
VCR
DSS/
CABLE
DVD
' " " NUMBER
QD QD QD keys
(3D QD (3D
_* _"_ " ENTER
_:tu_r spB
\ J
CABLE/DSS
POWER, ENTER,
NUMBER keys
(except 100key),
CHA/V
* Bold: VCR Function Bold Italic: VCR and DVD Functions
Italic: DVD Function Normal: TV, Cable Box or DSS Receiver
• Not all functions listed may be controllable.
• In TV or DSS/CABLE mode, it may be necessary to press ENTER after pressing
NUMBER keys for channel selection.
28