Panasonic DoubleFeature PV-D4753S Operating Instructions Manual page 10

_'. " i • I I']_=I
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 4 W of
electrical power in off mode.
p. 12
Component Video Output
Connector (Y, P_, PR) (DVD Only) --7\ Video Output Video Input
Connector Connector
p. 13 \ p. 35
Bold: VCR Function Italic: DVD Function
Bold ltalic: VCR and DVD Functions
VHF/UHF Antenna Output Terminal
p.t2
VHF/UHF Antenna Input Terminal
_,\p. 12\
5.1oh Analog Audio Output
Connector (CENTER, SUB WOOFER,
SURROUND L/R, FRONT L/R)--\
(OVD Only) p. 15
\\
\
Optical Digital Audio S-Video Out Audio Output2 Audio Input
Output Connector Connector Connector (L/R) Connector (L/R)
(DVD Only) (OVD Only) p. 13 p. 35
p. 15 pp. tO, 13
Audio Output 1
Connector (L/R)
p. 12
The following table shows the status of the output jacks when in VCR or DVD mode.
_ Video Output Component S-VIDEO OUT
_ Audio Out 1 Video Output
-__
Audio Out 2
VCR YES N/A N/A
DVD YES YES
_1 o PROG functions on the remote are not available when using Component "Video O_put
and S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press
PROG.
•To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals o_ a television.
(See p, 13.)
(2). When the PROGRESSIVE button is pressed, the ON lamp lights up (see p. 9) and the
PROGRESSIVE SCAN signal is output from the Component Video Output Connector.
Notes
• The PROGRESSIVE button can be operated when the DECK is in DVD function mode.
° The screen may ehi_ off-center when using p_ogreseive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• The DECK outputs video signals (not PROGRESSIVE SCAN) from the "VIDEO OUT" and
"S-VIDEO OUT" terminals whe_ the ON lamp is lit.
10