Table of Contents
Advertisement
TROUBLESHOOTING
WARNING:
Always remove the battery pack when servicing or transporting the mower. Always protect your hands
by wearing heavy gloves or wrapping the cutting edges with rags or other materials when performing any maintenance
on the mower blade.
PROBLEM
The mower fails
to start
The mower cuts
unevenly
Short running time
of the mower with
included battery
The mower does not
mulch properly
14
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2110E-SP
CAUSE
◾
The battery pack is depleted.
◾
The battery pack is not mounted in place in
the battery compartment.
◾
The battery or mower circuitry is too hot.
(The power indicator on the mower shines
orange).
◾
The side rails are not extended to their
maximum length and the clamps are not
locked in position.
◾
The handle is not set at one of the three
operating positions.
◾
The mower deck is clogged with grass and
debris.
◾
The blade is dull.
◾
The cutting height is not set properly.
◾
The blade is assembled incorrectly.
◾
Grass conditions and cutting height setting
will greatly affect the battery run time. The
claimed run time is based on a light load
condition.
◾
Wet grass clippings are sticking to the
underside of the deck.
◾
The mower is set to cut too much grass at
once.
SOLUTION
◾
Charge the battery pack.
◾
Attach the battery pack to the
mower; press it until you hear a
click.
◾
Allow the battery pack or mower
to cool until the temperature drops
below 67°C.
◾
Fully extend the handle and lock
both clamps.
◾
Adjust the handle to one of the three
operating positions.
◾
Clean the mower deck and make
certain that the blade has freedom
of movement.
◾
Sharpen or replace the blade.
◾
Raise the deck to a higher cutting
height setting.
◾
Reassemble the blade, following the
section "INSTALLING THE BLADE"
in this manual.
◾
Raise the blade height and slow
your pace to reduce the cutting load.
◾
Wait until the grass dries before
mowing.
◾
Raise the deck to a higher cutting
height setting.
Advertisement
Table of Contents
