Advertisement
FEATURES
BEFORE OPERATION
High power output
5 band graphic equalizer
System remote contro!
=
Stereo double cassette tape deck
Synchronized recording start
High speed copy
Relay play
Auto tape selector
Auto recording fevel
Quartz PLL synthesizer FM/AM tuner
Up to 24 stations random pre-set
CHECKING ACCESSORY
ITEMS
®
Size "AAA"
(IEC RO3) 1.5V
(UM-4) dry cell batteries
@
Remote control unit
=e
° FM T-type antenna
BEFORE OPERATION
REMOTE CONTROL UNIT
¢
AM
loop antenna
[1] Remove the cover of the battery compartment on the reverse
side of the remote control unit.
[2] Take out the two size "AAA" [IEC RO3 (UM-4)] dry cell batteries
supplied and load them into the battery compartment, taking
care to follow the markings on the compartment.
[3] Replace the cover of the battery compartment.
Cautions for handling dry cell batteries.
Misusing dry cell batteries can result in electrolyte leakage or explo-
sions. Bear in mind the following points for getting the most out of
your batteries.
@
When loading the batteries into the battery compartment, make
sure the plus ® and minus © polarities correspond to the mark-
ings on the compartment.
@
Even though they may be the same shape, batteries come with
different voltage ratings. Do not mix or use different types of bat-
teries together. Use only the same kind of batteries.
@
Do not mix up new batteries and used batteries but replace ali
the batteries at the same time.
@
Do not heat up, disassemble or shortcircuit batteries or throw
them into a fire.
@
Some batteries are rechargeable while others are not. Observe
the cautionary notes on the batteries and use them properly.
TURNTABLE PL-8882Z, PL-777AZ
INITIAL TURNTABLE SET-UP
Note:
H
The PL-777 AZ is not equipped with a dust cover.
}
1 « Check the accessories.
S
EP adaptor
Platter mat
2 s Remove the two clampers and the platter.
After turning the clampers in the direction shown in the
diagram, remove by lifting up.
Clampers
3 » Engage the belt on the back of the platter with the
fingers.
4 a Install the platter on the platter shaft and engage the
belt on the motor pulley.
Slowly rotate the platter by hand and make sure the belt
is correctly engaged on the motor pulley as shown in
the diagram.
Platter mat
5 = Place the platter mat on the platter.
6 s Remove the vinyl band holding the tonearm.
7 = Remove the tonearm from the arm rest.
o> P
8 = Remove the stylus cover.
is
<ARB1057>
Advertisement
