Advertisement
. Set the POWER switch to ON.
. Load a tape for recording in the Deck 11.
. Select the DOLBY NR switch.
. Turn down the volume control to minimum position.
8. Hold down the REC (@) switch and then press the PLAY
(>) switch of Deck II.
and recording will start.
oR
WN
NO
WAKE-UP PLAYBACK (Deck I and II)
1. Set the POWER switch to the stand-by position and con-
nect the power cord to the outlet on the audio timer.
. Set the POWER switch to ON.
- Select the DOLBY NR switch.
. Load the tape which is to be played back.
. Adjust the volume control to produce the level of volume
required when timer playback starts.
6. Set the time on the audio timer so that the power comes
on at the desired time. (Power to the cassette deck receiver
should be off at this point.)
7. Press the PLAY (I>) switch.
At the preset time, the power is switched on and the play-
back starts automatically.
A PhwN
Depress both PLAY ( >) switches (Deck | and Deck II). At
the preset time, the POWER is switched on and the relay
playback starts automatically.
Operations will vary according to the audio timer used. For
details, see the operating instructions supplied with the
audio timer.
MIXING KNOW-HOW
Mixing involves combining the signals from two input sources
{a microphone and a tape, for example)
1
3,7
'
SoS
®
16
<ARB1057>
SINGING ALONG WITH A PROGRAM SOURCE
Operate after setting the MIXING LEVEL control to minimum.
1. Perform the preliminary operations on page 12.
2. Plug a microphone into the MIC jack.
3. Adjust the volume to a suitable level.
4. Set the MIXING LEVEL control to the center position.
° If howling occurs {a high-pitched sound from the speak-
ers), take the following steps.
(1) Move the microphone away from the speakers.
(2) Lower the volume.
5. Select the desired program source using the FUNCTION
switches.
. Start playback of the program source.
. Adjust the overall volume.
. Using the MIXING LEVEL control, adjust the sound balance
between the microphone and the program source.
. Sing along with the program using the microphone.
OND
©
NOTE:
©
Recording of mixed sound is not possible.
°
When not using the MIXING function, be sure to set the MIX-
ING LEVEL control te SOURCE and remove the microphone
plug from the MIC jack.
Advertisement
