Maintenance Computer Network Setup; Programming The Imx Processor - CalAmp LMU-5541 Hardware And Installation Manual

Table of Contents

9/28/23, 4:30 PM

Take an Ethernet cable and connect one end to the LMU-5541™ RJ-45 connector and the other end to the maintenance computer.

Launch the terminal emulation program.

Power up the LMU-5541™.

Type: AT#ESN? <Enter>

Write down the ESN of the unit.

Remove power from the LMU-5541™.

8.3 Maintenance computer network setup

Change the IP settings on the maintenance computer to match the subnet of the LMU-5541™

Go to Control Panel → Network and Internet → Network and Sharing Center → Change adaptor settings → Local Area Connection → Properties → Internet

Protocol Version 4 (TCP/IPv4) → Properties →

Select "Use the following IP address:"

Enter the following IP settings:

Ethernet IP address = 192.168.1.189

Subnet mask = 255.255.255.0

Default gateway = 192.168.1.55

Ensure WiFi is disabled on the maintenance computer.

Apply power to the LMU-5541™, then view the terminal emulation screen.

Enter <B> to break the u-boot.

Net: FEC [PRIME]

Normal Boot

Hit 'B' to stop autoboot: 0

LMU5541-Boot >

The command prompt "LMU-5541-Boot >" will appear.

Type: nand erase.chip <enter>

LMU5541-Boot > nand erase.chip

https://puls.calamp.com/wiki/LMU-5541_Hardware_%26_Installation_Guide

LMU-5541 Hardware & Installation Guide - PULS Wiki

Select OK

26/29

Table of Contents