Advertisement
XL-V163TN/V164BK
XL-V263TN/V264BK
8. Installing the Laser Pickup
Shaft stopper
9. Removing the spindle motor
1) Remove the Mechanism assembly.
2) Remove the turntable, and remove the two
screws retaining the spindle motor.
3) Remove the screw retaining the spindle and the
Feed Motor P.C. Board and unsolder it.
1-26 (No.20392)
i
a. tt
Spindle motor retaining screws
Turntable
i
10. Installing the spindle motor
1) Tighten the 2 screws to the same torque.
2) Fasten the Spindle and the Feed Motor P.C.
Board with the screw and solder.
3) Install the turntable.When installing, press
straight down at the center of the turntable
until the distance from the surface of the
mechanism base to the top of the turntable is
exactly 19.4 + 0.1mm.
19.4
+0,1mm
4)
After insertion is complete, bond the motor
shaft and turntable together (at the section
marked by an arrow in the figure on the left
below).
CORRECT
~, INCORRECT
5) Use "LOCKTITE" #460 bonding agent, and
apply as little as possible. Take care not to allow
any excess bonding agent to get onto the
turntable. Be extremely careful not to allow
bonding agent to adhere to the motor bearings
(the section marked by an allow in the figure on
the right).
AE R
Ee Se E S
TLE OMe O S e
I
N
a eo A S b
Ned ote a P a
N
ee e
S a
Advertisement
