Table of Contents
Advertisement
RECORDING
Preparation
* Wind up to the point where recording will start.
* Use normal (type I) or CrOz (type II) tapes.
1 Insert the tape to be recorded on into deck 2.
Press the EJECT & mark to open the cassette holder.
Insert the tape with the side to be recorded on first facing you
and the exposed side down.
;
2 Set DOLBY NR.
To record with DOLBY NR: Press the DOLBY NR button to turn
on the OO NR indicator.
To record without DOLBY NR: Press the DOLBY NR button to
turn the indicator off.
3 Set the reverse mode.
Each time the REV MODE button is pressed, the reverse mode
changes.
To record on one side only, turn on =.
To record on both sides, turn on =).
4 Press the CD button.
y)
5 Load a disc onto the disc tray.
6 Press the @ REC/REC MUTE button to start record-
DOLBY NR
ing.
Playing and recording start simultaneously with the first track.
When you use the remote control to start recording, first press
the @/O REC/REC MUTE button and then press the <>
3
'
button within 2 seconds.
REV MODE
To stop recording from the CD
(DECK 2)
cote
de
UU
U U
Press the ll button to stop the deck, and press it againto stop the
CD piayer.
After play stops at the end of the CD
Deck 2 enters recording stop mode.
To record selected tracks
Before pressing the @ REC/REC
MUTE button, program the
tracks. (See page 30.)
To record part of the CD
When the @ REC/REC MUTE button is pressed, recording always
starts from the first track. To start in the middle of a track, play the
CD upto the point where you wantto start recording, andtinen press
the @ REC/REC MUTE button.
REC/REC MUTE
ft.
ie
;
Penta
Bishi]
cea
R OBO
{aura
/w inifelshe)ss}
f wareux [ef TTT]
Advertisement
Table of Contents
