Major Operating Controls And Their Functions - Panasonic WV-BM80 Operating Instructions Manual

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
1. Power ON/OFF Switch (POWER)
This is a push type switch which turns the monitor On
and Off.
Push once and the switch remains down ( m ) for
turning on the monitor and cameras.
Power and camera number indicator lamps light on.
Push again, the switch comes up ( ML) for turning off
the monitor and cameras, and the lamps go off.
2. Input Selection Switch
(INPUT SELECT, EXT/CAMERA)
This selects the condition of monitor as;
EXT: .
VTH playback picture or an external camera
connected to the Video Input Connector (B) can
be observed.
CAMERA:
Camera picture connected to Camera Input
Connector (10) can be observed.
3. 3-Position Selector Switch
1)
2)
3)
BYPASS mode
When the switch is set to this mode, the signal of the
camera in that position will be skipped regardless of the
presence of video signal. In other words, the signals
from that camera will not be fed out to Video Output
Connector (9).
AUTO mode
When the switches are set to this mode, the signal from
the camera will be switched automatically in sequence.
SPOT mode
When this mode is selected, the signal of the camera
in that position will come out of the Video Output
connector (9) so that the camera signal can be
selectively monitored. If two or more cameras are set
' to this mode, the signal of the lower-numbered camera
will be fed out to the Video Output Connector (9).
Time Adjustment (TIME ADJ, MIN/MAX)
The interval of the sequential switching can be manually
adjusted from 1 to 30 seconds by adjusting this knob.
Vertical Hold Control (V. HOLD)
Locks in the picture of monitor vertically.
Bright Control (BRIGHT)
Turn this contro! clockwise to increase the picture
brightness.