Depth Stop Adjustment; Fence Extension; Bevel Lock Tension Adjustment - Delta 26-2312 Instruction Manual

DEPTH STOP ADJUSTMENT

This miter saw is equipped with an adjustable depth stop for
making non-through cuts.
See Figure 15 and follow these instructions in order to
set the depth stop at a specific cut depth:
1.
Flip the depth stop plate
down position.
2.
The cut depth can now be adjusted by turning the
depth stop screw
F5
3.
Lock the adjustment screw by turning the wing-nut
until snug against the depth stop plate
NOTE: When finished with non-through cut, flip depth stop
plate Clockwise to return to through cut position.
F5

FENCE EXTENSION

See Figure 16.
This saw is equipped with an adjustable sliding fence. To
extend or retract the fence follow these instructions:
1.
Loosen the lock knob
and then slide the fence
2.
Make sure to re-tighten lock knob
Clockwise.
ALWAYS check to make sure lock knob
is tightened before making a cut. Failure to do so may result in
injury.
BEVEL LOCK TENSION
ADJUSTMENT
See Figure 17.
1.
With the miter saw head in an unindexed and locked
bevel angle, check that the head will hold it's position
when pushed with moderate sideways pressure.
2.
If head moves easily, then adjustment is required.
3.
Release the bevel lock/unlock lever.
4.
Hold the central post
tighten the 17mm Lock Nut
side pressure when locked in an unindexed bevel angle.
NOTE: Correct tension is when the cutting head will hold
position when not indexed and unlocked. This ONLY applies at
angles 0 - 20°.
ADJUSTMENTS
Counterclockwise into the
F5
.
.
F5
by rotating Counterclockwise
B
into the desired position.
F7
by rotating
B
using a T-25 Torx wrench and
C
until the head will resist
D
F5
A
LOOSEN
B
17
F5
A
Figure 15
F7
TIGHTEN
B
Figure 16
C
Figure 17
D