JVC GX-N7E Service Manual page 40

3. To disassemble EVF hood, remove the eye cap in the [— J
direction of the arrow as shown in Fig. 12-3. REMOVING THE EVF, BOARD AND CRT
4. Press the clip securing the lens in the direction of the
1. Remove the two screws (@) shown in Fig. 13-1. :
arrow and remove fens, as shown in Fig, 12-4.
2. Remove the EVF cover by lifting in the direction of
5. Pull the lock plate in the direction of the arrow the arrow as shown in Fig. 13-2. .
shown in Fig. 12.5,
3. Removing the CRT socket and connector shown He
1
NOTE: When locking the EVF hood becomes impos- Fig. 13-3 will allow the circuit Beardie ye pe pee
sible while shooting under special atmospheric
oN
4. Removing the two ®) screws shown in a "
conditions (high
temperature/humidity), use
allow disassembly of the CRT and DY assembly.
the EVF by slightly bending the tock plate.
Eye cup
EVF BOARD
Lens
Fig. 12-4 Disassembling the EVF (4)
"Lock plate
Fig. 12-5 Disassembling the EVF (5)
LED light guide
Screw ®
Pate
(No. 5550) 15E !
16E (No. 5550)