Table of Contents
Advertisement
=m DISASSEMBLY
& REPLACEMENT
OF BIAS
LIGHT & OPTICAL LOW-PASS FILTER
1. Remove the connector shown in Fig. 9-1.
2. Fig. 9-2 shows disassembly method.
NOTE:
When replacing the BIAS tight board and LPF,
be
sure
to confirm
which
sides are back
and
front and which are top and bottom.
a
REMOVING THE GRIP BELT
1. Remove the two screws (a) shown in Fig. 10.
Connector
LPF & BIAS LIGHT
Fig. 9-1
Disassembly & replacement of bias light & optical
low-pass filter
~ thee
=
cath
—————
length
—~t—_
TUBE
{
>.
at
—P
LENS
AWN
Bias light board
Fig. 9-2
Disassembly & replacement of bias light & optical
low-pass filter
Screw (a)
Body cover
Fig. 10
Removing the grip belt
{No. 5550) 13E
= REMOVING THE VTR SWITCH
_ | = DISASSEMBLING
THE ELECTRONIC
VIEW.
FINDER (EVF)
shaft and detach the EVF arm.
1
pull the EVF hood
in the direction of the arrow.
|
be adjusted while EVF hood is removed.
14€ (No. 5850)
|
|
1. Remove the & ring shown in Fig. 12-1, pull out the
1°
2. While pressing the button
(A) shown in Fig. 12-2,
NOTE:
FOCUS, BRIGHT, V. HIGHT and H. HOLD can
VCRIVTR) SW BOARD
Screw "a)
|
Beoal
Fig. 11-1
Removing the VCR (VTR) switch (1)
®
E ring
EVF hood
Y
Fig. 12-2
Disassembling the EVF (2)
Advertisement
Table of Contents
