Motor Test Mode.65 - Star Trac 4500 Owner's Manual

Motor Test Mode
Motor Test Mode allows you to calibrate incline and running belt speed, and bum in the motor, by
way of the controls and displays of the treadmill. To enter Motor Test Mode:
• Enter Manager Settings (or Maintenance'Settings).
• Press and hold 0, O' and ISTARTI together (or Q, 0, and ISTARTl together).
• Release
0
)-
• Listen for a beep and see MANAGER SETTINGS (or MAINTENANCE SETTINGS) in the
display momentarily.
• Release the remaining keys. See UNITS in the Alphanumeric Display.
• Press and release
• See three data items in the Alphanumeric Display. Or...
Alternatively, to enter Motor Test Mode from Operating (normal) Mode:
• Move the ON/OFF switch (main power switch @ the rear of the unit) to OFF.
• Press and hold ||j while moving the ON/OFF switch to ON.
• Release
|=j).
• See three data items in the Alphanumeric Display, shown below.
ALPHANUMERIC DISPLAY
Blank = Both Tests
Z=EIevation Test
M=Motor test
4- i—
Speed in mph or km/hr
^
Q
n □, □ □□1 1 ^ □ □ Q d
Use elevation keys to change: Use the
Use speed keys to change:
The data items in the Alphanumeric Display are, from left to right:
• Elevation (Incline): Representation of voltage to elevation motor. Multiply by 0.019608 to get
actual voltage. Letter Z or M follows numeral data where Z signifies elevation and M signifies
motor, and a blank signifies both elevation and motor.
• Pulse-width modulation (PWM) duty cycle. Divide by 512 to get percent duty cycle.
• Speed in mph (UNITS=English) or km/hr (UNITS=Metric).
STAR TRAC4500 TREADMILL Owner's Manual
65