Page 2
Thank you for choosing a high-quality product “MADE IN GERMANY” from the brand TW AUDiO. The VERA LA900 load adapter (with shackle) is an accessory part for the rigging frames of the VERA20 and VERA36 series. It is characterized by a subtle look, a remarkable size to weight ratio and ease of use.
Page 3
Notes on the products Before using the load adapter, carefully read the assembly instructions and keep the instruc- Read manual tions in a safe place together with the VERA LA900 load adapter. before use! General Information Assembly Guide: OM -VERA LA900 Version 2.0 d, 11/2022...
Components ......................7 3. Technical specifications ....................8 Data sheet ....................... 8 4. Commissioning ....................... 9 Use of VERA LA900 load adapter ................9 Compression mode ....................11 5. Transport and Storage ....................12 6. CE Declaration of Conformity ..................13...
The VERA LA900 load adapter may only be used by trained and qualified personnel. Personnel must check the VERA LA900 for its full suitability before each use. WARNING When visible damage to any part of the VERA LA900 load adapter is detected, it must be decommissioned immediately. WARNING...
Page 6
The VERA LA900 load adapter is designed for a payload of 1.5 to [3307 lbs]. WARNING Do not exceed this payload! Check the screw connection at every installation of the VERA LA900 load adapter . Tighten if loose. If this is not possible, replace the fasteners. WARNING...
Assembly Instructions VERA LA900 3. Technical specifications Data sheet maximum load capacity 1,5 to [3307 lbs] (3 to WLL) [6614 lbs] Dimensions (h x w x d) 150 x 100 x 70 mm [5,91 x 3,94 x 2,76 in] Weight 1.1 kg [2,4 lbs]...
Figure 4.1.1 - VERA LA900 load adapter Two quick-locking pins are attached to the VERA LA900 load adapter. Fasten the VERA LA900 load adapter to the rigging frame of the VERA20 und VERA36 series with both quick-locking pins! WARNING Use the EASE Focus simulation software to determine the appropriate pin points for your application.
Page 10
BOTH PINS Figure 4.1.3 - VERA LA900 load adapter set to position 26,5 - facing forward If the quick-locking pin of the VERA LA900 load adapter is moved from 26 to 25, this results in a pin point of 26,5.
BOTH PINS Figure 4.1.5 - VERA LA900 load adapter set to position 25,5 - facing rearward If the quick-locking pin of the VERA LA900 load adapter is moved from 26 to 25, this results in a pin point of 25,5.
Assembly Instructions VERA LA900 5. Transport and Storage Ensure that the surface of the load adapter is not damaged during transport and storage. Moisture may penetrate where steel surfaces are exposed by scratches and result in corro- sion. NOTE This is why the product should be transported and stored in a safe, careful, dry and largely dust-free manner.
Assembly Instructions VERA LA900 6. CE Declaration of Conformity Copy and translation of the original CE Conformity Declaration: We hereby declare that the below-referenced components by virtue of their design and con- struction, and in the configuration placed on the market by us, satisfy the safety and health requirements of the applicable EC directives.
Need help?
Do you have a question about the VERA LA900 and is the answer not in the manual?
Questions and answers