Parts Identification/Accessories - Panasonic NP-TH1WEVN Operating Instructions Manual

Parts Identification/Accessories

Nozzle (back)
Nozzle (top)
Nozzle
(bottom)
Filter
(page EN13)
Upper basket
■ Removing the basket
As shown in the illustration, lift up the convex
part of the basket from the concave part and
pull it out.
Convex
Concave
■ Attaching the basket
To attach the basket, do the reverse of
removing it.
● The shape and colour of the illustrations in this manual may differ from the actual appliance. Please refer to
the actual dishwasher.
EN3
Open Door
button
Back of the appliance
Rails
(right and left sides)
Drain hose connector
Power cord
Supply hose connector
Lower basket
■ Removing the basket
Pull out the basket, then lift up to take out.
■ Attaching the basket
Align the rails and slide in.
Control panel
6
4
Door
1
2
3
4
5
Cutlery basket
The cover
grid can be
removed
6
following the
direction of
the arrow
❶ Supply hose (1)
❺ Clamp (1)
Reminder
● ❹ is in a small bag and it is in a large bag with ❸ and it is included with other accessories.
● ❼ can be split into 4 parts.
● Please refer to Installation Instructions. (page EN19)
Display
3
Power button
● Press this button to power on or off the dishwasher.
● After the power is turned on, by default it is automatically set to the program of the
last operation (except if the last program was "Dry Only")
Program button
● In selecting the wash program, each time you press the button, you can switch the
wash mode. The display indicators will light up in turn to show the corresponding
mode. (page EN10)
Dry button
● Each time you press it, you can switch the drying mode, and the display indicators
will light up in turn to show the corresponding mode. (page EN11)
Delay Start button
● Press this button, the program will start to operate automatically 4 hours later, and
the indicator "4 hours" will light up.
● Press the button again, it will cancel the Delay Start setting. The "4 hours" display
indicator will light off.
Start/Pause button
● Press this button to start operation. If you press this button during operation, the
operation will pause. Press it again, the operation will continue.
● If you do not press this button after the above steps, the power will be turned off
automatically after 10 minutes.
● If the door is not closed, pressing this button will not start the operation.
● The display indicator "Salt" will light up if the dishwasher salt is not adequate. For
option code "0", "Salt" does not light up. (page EN9)
Accessories
❷ Drain hose (1) ❸ Three-way connector (1)
❻ Sucker (1) ❼ Protective sleeve (bolt set) (1)
Bolt
Nut
5
1
2
❹ Gasket (3)
● Splitting
① Unscrew ② Open in the
direction of the
arrow
EN4