Panasonic NP-TH1WEVN Operating Instructions Manual page 13

Installation Instructions
❷ connect to the supply valve
direct installation
water supply hose
screw tight
gasket
supply valve
Important
● Do not miss out the gasket when installing (it may cause water leakage).
Recommendation
● If it does not affect the usage of other water pipes, it is recommended to close the supply valve after
each operation.
■ Confirming the tap water pressure
Please use the appliance at an inflow water pressure of 0.05 MPa - 1 MPa. When operating the water tap in the
kitchen, be sure to install the specified pressure relief valve if the tap water pipe generates abnormal sounds
(water hammer phenomenon).
When the water tap is fully open, the rate of inflow is required to reach at least 8 L per minute.
Please contact the Service Centre to confirm the water pressure and rate of inflow.
EN21
(cont.)
three - way connector installation
water supply hose
screw tight
gasket
three-way
connector
screw
screw tight
other pipes
tight
gasket
supply valve
4
Secure the drain hose with a sucker
Drain hose
→ If the drain hose is too long, cut neatly at the appropriate position
along the core wire (transparent).
sucker
5
Trial operation
Make sure that all adhesive tapes used to fix the door and inside of the dishwasher and the packaging bags
of all parts have been removed.
Make sure that the supply valve is open, plug in the power plug and close the door.
Please perform a trial test of the dishwasher according to the following procedures.
• If there is no water supply and electricity supply temporarily, perform a trial test of the dishwasher when
water supply and electricity supply resume. (Do not fill in water by hand)
■ Procedures for trial operation
❶ Press to turn on the power
❷ Press and hold for more than 3 seconds simultaneously
• The indicators for Speedy and Care in the display light up and emit 2 beep sounds
❸ Press to start the trial operation
• Please confirm the following during and after the operation.
• Power will automatically be turned off and the display indicators light off after completion of the trial
operation
■ Trial operation confirmation
During operation
Error indication : There should be no alarm sound nor abnormal indication on the display.
(page EN16)
Water leakage : There should be no leakage at the joints of the water supply hose and drain hose.
When the operation completed
After 6 beep sounds, power will be automatically turned off
Drainage condition : Open the door and confirm that the water inside the dishwasher has been
drained out.
No water supply condition : When the power is off, confirm that no water is draining out from the drain
outlet.
Reminder
After the trial operation is completed, keep the supply valve open.
If the dishwasher will not be used for a long time, close the water valve to avoid water leakage.
If freezing may occur, arrange draining treatment. (It may cause damage to the supply valve resulting water
leakage) → If freezing occurs, contact Service Centre
EN22