How To Make Copies; Initiating A Copy Operation; Commands For Customizing Copies - Tektronix 4106 Operator's Manual

HOW TO MAKE COPIES
HOW TO MAKE COPIES
The following procedures show you how to make both color and monochrome hard
copies of the display. (If you are using a host program that selects copier attributes
or initiates copies for you , you should follow the host program 's procedures instead
of these.)
You can make color copies on these copiers:
• Tektronix 4691 Color Graphics Copier
• Tektronix 4692 Color Graphics Copier
• Tektronix 4695 Color Graphics Copier
You can make monochrome (black-and-white) copies on these copiers:
• Tektronix 4644 Dot Matrix Printer
• Hewlett-Packard ThinkJet
• Centronics-style printers that use Epson FX-80 graphics protocol
Additionally, you can make copies of just the text in the dialog buffer on most
Centronics-style printers that don't have graphics capability (that is, without
Epson-style graphics).
Copies of the dialog buffer are called dialog copies and copies of the graphics area
are called graphics copies .
INITIATING A COPY OPERATION
To make a copy, follow these steps:
1. Be sure that the copier is installed and that both it and the terminal are
powered up (Appendix A tells how to con nect and set up all the peripherals).
2. Put the terminal in Setup .
3. At this point you can customize your copy by changing the terminal's default
settings. Table 3-1 shows which commands you can use with your copier;
these commands are described in detail later in this section . Be sure to enter
Setup before issuing these commands.
Table 3-1
COMMANDS FOR CUSTOMIZING COPIES
4691
4692 4695 Monochrome
Monochrome Text
Graphics Printer Printer
HCDAATTRIBUTES HCDAATTRIBUTES HCDAATTRIBUTES HCDAATTRIBUTES HCDAATTRIBUTE
s
HCSIZE
HCSIZE HCSIZE HCMAP
HCORIENT HCORIENT
HCDATARES
HCDENSITY
HCREPAINT
3-10
4106/4107/4109 OPERATORS