Your Next Step - Tektronix 4106 Operator's Manual

GETIING ACQUAINTED
YOUR NEXT STEP .. .
You have now completed your introduction to using the terminal for routine
graphics operations. By this time , you should have a basic understanding
of how to :
• Enter commands
• Use the dialog and graphics areas
• Create graphics
• Change color definitions
• Use the Zoom/Pan function
• Enter graphics points for graphics input (G IN)
At this point you may want to :
• Go on to Section 3 and try some of the specific tasks that are explained there.
• Continue entering Setup commands . For reference you can use the Setup
Command Table in Section 4 of this manual. Or you might look through the
41061410714109/CX Reference Guide. If you have the optional
41061410714109/ CX Programmers Reference Manual,
you may want to review it.
• Log on to your host computer and run an application program . Before you do so ,
however, make sure the term inal 's communications parameters have been set
to the requirements of your host computer (refer to Appendi x A for connecting
the terminal to a host).
When you 're finished , turn the terminal off or reset it for the convenience of the
next user. (To reset the terminal , enter a RESET command or press the RESET
button on the rear panel of the display unit.)
2-42
4106/4107/4 109 OPERATORS