Table of Contents
Advertisement
INSTALLATION AND SETUP
4691 AND 4692 COLOR GRAPHICS COPIERS
1.
Plug
the copier cable into the
COPIER
port
.
Secure the cable connector with
the two clips
attached
to the port.
2.
Put the terminal in Setup and enter the following command:
HCINTERFACE
2
The parameter value (2) tells the terminal you are using a Tektronix 4691
,
4692,
or 4695 Color Graphics
Copier.
3.
Save
the setting in nonvolatile memory by entering
:
NVSAVE
4695 COLOR GRAPHICS COPIER
1.
Plug the copier cable
into
the
COPIER
port. Secure the
cable connector
with
the two clips attached to the port.
2.
Put the terminal
in
Setup and enter the following command
:
HCINTERFACE 2
The parameter value (2) tells the terminal you are using a Tektronix 4691
,
4692
,
or 4695 Color Graphics
Copier.
3.
Save the setting in nonvolatile memory by entering
:
NVSAVE
4.
You may also need
to
set the
C
and
M ADJUST
switches on the rear panel
of
the 4695.
•
Switch
C
tells the copier whether to ignore Carriage Returns from
the
terminal. If the copier double-spaces lines of text or prints a new line of
text
on top of the previous line, change the switch setting
.
•
Switch
M
tells the copier whether to print
in
one direction or
in
two
directions.
Bidirectional
printing is
faster,
but the dot alignment is better
with one-directional printing
.
For highest quality
copies,
use
the
slower,
one-directional setting
.
4106/4107/4109 OPERATORS
A-13
Advertisement
Table of Contents
