Table of Contents
Advertisement
Power-on LED
There is one I/O LED (green) on the front panel to indicate if the system is powered. For power-on
LED definitions, please refer to section
USB 3.0 Interfaces
UFM Cyber-AI Appliance offers 4x USB 3.0 ports on the system's rear panel. These interfaces can be
used to provide up to 500MB/s in bandwidth.
Do not use excessive force when inserting or extracting the USB disk into and from the port.
PCIe Gen 3.0 x16 Slots
UFM Cyber-AI Appliance is shipped preassembled with two ConnectX-6 VPI cards that enable the
hardware-based forwarding of IP packets from InfiniBand-to-Ethernet, and vice versa.
LAN Interfaces
UFM Cyber-AI Appliance features two 10G Base-T Ethernet LAN 1/2 connections (Intel X557 PHY (2*
10GbE)) and two GbE LAN 3/4 (Intel I210 (2* 10/100/1000 Base-T GbE)) to eliminate bottlenecks in
network data flow. The ports are accessible from the appliance's rear panel.
In addition, the appliance is equipped with a ASPEED 2500 BMC chip that supports IPMI 2.0 via LAN1
and LAN4 interfaces.
The recommended cabling when connecting LAN4 and LAN1 (for 10G LAN) is Cat. 6 (< 55m) or Cat.
6A (<100m), both cross and straight cables are supported.
LAN3 (X557-AT2 controller) has an internal signal connected to BMC LAN2.
•
For LAN1 and LAN2 LED definitions, please refer to section
Interface".
•
For LAN3 and LAN4 LEDs definitions, please refer to section
Interface".
If any of the LAN ports do not come up automatically, then please bring them up
manually.
Redundant Power Modules
UFM Cyber-AI Appliance is equipped with two redundant power supply units at the rear of the
appliance. The PSUs are housed in a 2U canister containing the power supplies. Each PSU has an
extraction handle, PSU status LED, and a power socket.
"Power-on
LED".
"LAN1/LAN2 Rear I/O LED
"LAN3/LAN4 Rear I/O LED
11
Advertisement
Table of Contents
