Check Battery - Ariens IKON XD 42 Operator's Manual

DO NOT sharpen to this
pattern.
2
Sharpen to this pattern.
3
DISCARD if more than
1.3 cm (1/2")
1. Cutting Edge
2. Square Corner
3. Air Lift Erosion
4. Air Lift
Figure 20
CAUTION: Unbalanced blades
cause excessive vibration and
eventual damage to unit.
Balance blades before
reinstalling on unit.
NEVER weld or straighten
blades.
3. Check blade balance by sliding blade on
an unthreaded bolt. If blade does not
remain horizontal, sharpen the heavy end
until blade is balanced.
Install Blades
1. Reinstall blades, washers and nuts on
spindles. See Figure 19.
2. Torque bolts to 136 N•m – 163 N•m
(100 lb-ft – 120 lb-ft).
1
1
4
EN - 20

CHECK BATTERY

WARNING: Battery posts,
terminals and related
accessories contain lead and
lead compounds, chemicals
known to the State of California
to cause cancer and
reproductive harm. Wash hands
after handling.
Remove Battery
1. Place unit in service position. See
Service Position on page 18.
2. Disconnect the negative cable and then
the positive cable from the battery.
See Figure 21.
3. Remove hardware retaining battery
bracket and remove bracket. Retain all
parts for reinstallation.
4. Remove battery.
2
3
1
1. Battery
2. Battery Bracket
3. Mounting Hardware
Figure 21
Install Battery
Install Factory Battery
See Figure 21.
1. Reinstall battery into unit.
2. Install battery bracket over battery and
onto bolts in battery tray. Secure with
original hardware.
3. Connect positive cable to positive battery
terminal and then the negative cable to
negative battery terminal.
4. Return seat to operating position.