Battery (Electric Start Models) - Ariens 927 Series Owner's Manual

Hide thumbs Also See for 927 Series:
Table of Contents

Advertisement

N
/
Lubrication and Maintenance (Continued)
Muffler:
Worn out mufflers.are more than just a noise
nuisance and should be replaced immediately.
Continued use could result in fire or explosion.
Battery (electric start models)
WARNING:
Batteries produce explosive
gases which can cause personal injury.
'DO NOT allow flames, sparks or any ig-
nited object to come near battery. When
charging
or
working
near
a
battery,
-~ always shield your eyes
and
provide
- ventilation.
A
of children.
Batteries
contain
sulfuric
acid. Avoid
contact
with skin, eyes or
clothing.
In case
of acid contact
with
skin, eyes or clothing, flush immediately
-with water for a minimum of 15 minutes.
If acid is swallowed, drink large quan-
tities of milk or egg or vegetable oil. Call
'a physician immediately.
Every 25 hours or each week check electrolyte
-level of each cell by removing caps one at a
time. The electrolyte level should be at level in-
dicator. Use distilled water to fill each cell if
needed.
Install and
tighten
each
cap after
checking.
l
IMPORTANT: When distilled water is added to
'battery during freezing weather,
it must
be
charged to mix water with electrolyte or water
will remain at top and freeze.
Keep battery and its terminals clean and in-
spect monthly to be sure of obtaining best
performance.
"WARNING: DO NOT allow tools or other
ci A
'objects to come
into contact with both
terminals at same time. When removing
battery from tractor, remove negative (-)
'cable first to reduce risk of sparks.
WARNING: Keep batteries out of reach `
13
A
To charge battery remove battery from riding
To clean terminals remove battery from riding
mower
by removing cables.
Remove
battery
strap and hooks and lift battery out. Clean or
service
away
from
unit.
Remove
corrosion
from battery terminals and cable connections
with a wire. brush, then wash
with a weak
baking soda solution.
After cleaning, apply a thin coat of grease or
petroleum jelly to terminals and cable ends, to
retard corrosion. Reinstall battery. ~
CAUTION:
Connect
positive. (+) cable
first, negative (—) cable last.
mower, remove vents and charge at a rate of
1.2 amps for 10 hours on a fully discharged
battery.
IMPORTANT:
Charging at a higher rate will
damage battery.
l
A
WARNING:
When
charging
battery,
remove it from tractor and make certain
that you. connect
positive (+) lead of
charger
to positive (+) terminal
and
negative (—) lead to negative (—) ter-
'minal. Reverse
connections can
cause
sparks and potential unsafe conditions.
. Battery Cables
. Positive Terminal
. Filler Caps
. Battery Sirap
. Negative Terminal
aAhaoND
Figure 7: Battery Frame

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rm-928Rm-1232

Table of Contents