Various Machine Modes; Handlebar Adjustment - Husqvarna PG400 Operator's Manual

• Make sure that the brush list is intact and clean and
that it seals tightly against the floor. Damaged brush
list should always be replaced.
• The tool plate continues to rotate for a while after the
motor has been switched off. Maintain grinding action
until the fan has come to a complete stop. Ensure the
tool plate has stopped rotating before lifting up the
machine.
• When grinding adhesive, asphalt, paint or the like, lift
the front of the machine slightly after use to prevent it
sticking to the floor from the heat. Ensure the tool
plate has stopped rotating before lifting up the
machine.
• Diamond tools may be very hot after use. Leave
machine to cool off before removing the diamond
segments. Use protective gloves.
• Always use the machine mounted lifting eye when
lifting.
• Always carry the machine by the carrying handle and
the handle.

Various machine modes

Operating position
Service position
Tilting transportation position
OPERATING
Lifting transportation position
• Standing beside the wheel chassis, squeeze the
handle on the central hinge while simultaneously
angling the upper frame forward to the lifting position.
Lifting eye
• Always use the machine mounted lifting eye when
lifting.

Handlebar adjustment

The handle can be infinitely adjusted. The handle lock
knob has two positions, one locked and one open
position.
• Folding up the lock knob to open position will release
the clamp holding the handle and it can be adjusted to
the desired position.
• Fold back the lock knob to locked position.
1
1
2
–
English 9