Operation
7.4
Connecting the cooler
A
NOTICE! Damage hazard
• For protection of the device the DC cable supplied includes a fuse
inside the plug. Do not remove the fused DC plug.
Only use the DC cable supplied.
• Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
Connecting to a battery
® Proceed as shown (fig. 7, page 7).
Connecting to an AC power supply
D
DANGER! Electrocution hazard
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat from a AC power
supply, you must install a residual current circuit breaker between the
AC power supply and the cooler.
Seek advice from a trained technician.
® Proceed as shown (fig. 8, page 7).
26
CFX3
EN