Using The Ice Maker (Only Cfx3 55Im) - Dometic CFX 3 Series Operating Manual

Operation
7.13

Using the ice maker (only CFX3 55IM)

I
NOTE
• Independent of the main compartment's temperature setting, the
ice maker zone is designed for making ice cubes if the ice maker is
switched on.
• The cooler's energy consumption increases with ice maker on.
Therefore you should switch off the ice maker if it is not needed.
• The factory setting for the ice maker is OFF.
® Proceed as shown (fig. i, page 12).
Filling the ice trays with water
® Remove the ice trays (fig. j 1, page 13) from the ice maker housing (fig. j 2,
page 13).
® Remove the ice tray covers, fill with clean water and re-fit the cover, taking care to
press the edge seal all the way around.
® Re-position the ice trays in the ice maker housing and close the lid.
I
NOTE
Dry any water spillage from under the ice trays.
This will reduce ice build up under the trays and make removal easier.
Removing the ice cubes
® Open the ice maker housing lid and lift under the front of the ice trays.
I
NOTE
Removal may require additional force using two hands in high humidity
conditions which may create an ice bond underneath the ice trays.
® Remove the ice tray covers and twist trays to release the ice cubes.
30
CFX3
EN