Page 1
D I R T Y D E E + I N S T R U C T I O N M A N U A L T050801207P T050801208P T050801209P D A R C H E . C O M . A U...
Page 2
I N S T R U C T I O N M A N U A L CONTENTS • 1 x Dirty Dee + swag • 1 x Composite swag pole pack (9 sections that make up 3 poles) • 2 x Trigger lock spreader poles •...
Page 3
Prior to first use of the Dirty Dee + swag, it is important to remove the mattress from its compression sleeve and allow it to expand. Seasoning the swag is not essential but is recommended. For full instructions on seasoning your DARCHE swag, see How to Season Your Swag (page 7).
Page 4
I N S T R U C T I O N M A N U A L Step 4. The end of the pole will have the aluminium sleeve to insert the base pin. Insert the first pole end onto the base pin. Step 5 Insert the second END pole to the other end of the MIDDLE section angled pole sleeve.
Page 5
Step 7 Clip the swag to the composite poles one end at a time. A good technique for attaching the clips is to alternate from one side to the other. Top left then top right, second left and then second right and so on. At this point you should have all three composite poles assembled, located in their corresponding positions and have centralised the swag at each point.
Page 6
I N S T R U C T I O N M A N U A L Step 8 Insert the trigger lock spreader pole into one of the centre eyelets. Release the trigger to extend the pole and insert into one of the end eyelets.
Page 7
Allow to fully dry out before re-packing and storing. SPARE PARTS LIST For a full list of Spare Parts available refer to DARCHE.COM.AU HOW TO SEASON YOUR DARCHE SWAG The best way to season your swag is to set up outdoors and completely soak the exterior material of the swag with a hose.
Page 8
M A N U A L Designed and tested in Australia for Australian conditions. A brand by Charles Parsons. Telephone 1300 367 695 l Email: info@DARCHE.com.au 75 Heyington Avenue, Thomastown VIC 3074, Australia. DARCHE: LEADERS IN OUTDOOR DESIGN. PROUDLY AUSTRALIAN.
Need help?
Do you have a question about the DIRTY DEE+ and is the answer not in the manual?
Questions and answers