Designing An Interface Between A P6434 Probe And A Sut; Mictor Connectors And Latch Housings - Tektronix P6434 Instructions Manual

Designing an Interface Between a P6434 Probe and a SUT

Mictor Connectors and Latch Housings

P6434 Probe Instructions
This section provides you with some guidelines for designing your own P6434
probe interface on the SUT. The guidelines contain information on the following
topics:
Mictor connectors
Dimensions and placement of connectors
Mechanical layout and pinout of connectors
Probe channel assignments
Loading and equivalent circuits
The P6434 probe contains a 38-pin Mictor connector. Table 2 lists Mictor
connectors you can purchase from AMP, Inc., that are compatible with the probe,
as well as the compatible latch housings that are available from Tektronix.
Table 2: Compatible Mictor connectors
AMP, Inc.
part number Description
767054-1* Palladium-nickel plated, 0.054 inch long ground pins, surface mount
connector (vertical receptacles)
2-767004-2 30 microinches gold plating, 0.054 inch long ground pins, surface mount
connector (vertical receptacles)
767044-1* Palladium-nickel plated, straddle mount connector (0.062 inch circuit board
thickness, right-angle receptacles)
Tektronix
part number
Description
105-1088-00 Latch housing; straddle mount (0.062 inch circuit board thickness)
105-1089-00 Latch housing; surface mount
Recommended
*
You can contact AMP, Inc. for more detailed information on the Mictor
connectors. For the address, refer to the Replaceable Parts section.
7