BMW K 1100 LT 1995 Rider's Manual page 69

Storing motorcycle
Procedure
Clean motorcycle (see page 64).
Remove battery (see page 61).
Pay attention to maintenance instructions
(see page 62)!
Lubricate brake pedal and clutch lever
joints, center and side stand bearings.
Spray bright metal/chrome parts with
S$ 100 Corrosion Protectant.
Store motorcycle in a dry room on center
stand.
Place block under the engine so that both
wheels are off the ground.
Note
Before the motorcycle is laid up out of
use, ask your authorized BMW motor-
cycle dealer to change the engine oil
and renew the oil filter element.
Work needed in connection with laying
up the motorcycle or restoring it to the
road is best combined with an Inspec-
tion or Oil Service performed by your
authorized BMW motorcycle dealer .
67
Restoring motorcycle to use
Procedure
Remove protective coatings applied to
exterior.
Clean motorcycle (see page 64).
Install fully-charged battery (see page 61).
Treat battery terminal posts and clips with
protective grease.
Check/correct tire inflation pressure
(see page 33).
Check brakes (see pages 30-32),
Perform safety checks (see pages 25-36).