Table of Contents
Advertisement
What
happens
if | spin the rear
wheel during acceleration?
Spinning the rear wheel may cause the ABS
system to lose programmed coordination, as
the front wheel
is no longer synchronized
with the rear wheel. This loss of coordination
will cause the ABS unit to register a fault.
Faults registered from wheel spins will usu-
ally cancel themselves when the ignition is
turned "off". If not, you must visit your autho-
rized BMW
Dealer to have the control unit
"reset". Until the "reset" is performed, you
will not be operating with the benefits of ABS.
Important:
In the event of faults to the ABS or brake
system, allow an authorized BMW
Dealer
to repair the motorcycle as soon as pos-
sible.
Caution:
While it is well protected, the electronic
control unit can only withstand a certain
electromagnetic load.
You are therefore advised against using
high-performance
radio
equipment
on
the motorcycle,
as the ABS
may
other-
wise suffer from interference.
When working on the electrical system,
always switch off the ignition and discon-
nect the battery negative lead.
Advertisement
Chapters
Table of Contents
