BMW K 1100 LT 1995 Rider's Manual page 60

58
Renewing rear turn-signal bulb
Tools required
Screwdriver with reversible blade
Work sequence
e Place motorcycle on centre stand.
@ Take out retaining screw (1).
e@ Take out flasher cover (2).
e
Press plastic catch (3) to release bulb
holder, and remove it.
Press bulb in and turn to left to release.
Take the bulb out.
@ Insertnew bulb into catch and turn to right
to secure.
e Install in the reverse order of work.
— Front/rear indicator bulbs: = 12 V/21 W
Renewing rear light bulb and
brake light bulb
No tools required.
Procedure for removing bulb
e Place motorcycle on center stand.
e@ Open the dualseat. Remove the cover
from the storage compartment.
e Take out the two knurled screws (arrow).
@ Detach the rear light assembly.
Light assembly:
Top => brake
light
Bottom = rear
light
@ Remove the bulb insert (1) by pressing in
plastic catch (2).
@ Press the brake/rear light bulb (3) to the
rear and release it from its holder by turn-
ing it to the left. Take out the bulb.
e Install in the reverse order of work.
Brake light — 12V/21W
— Rearlight => 12V/10W
Note
Do not touch new bulbs with your bare
fingers.
Use a clean, dry cloth for installing.
If touching bulb cannot be avoided, re-
move finger prints before use.