BMW K 1100 LT 1995 Rider's Manual page 59

Electrical system
Caution
Perform work on the electrical system
only when ignition is switched off or bat-
tery negative cable disconnected!
Do not touch any live parts when engine
is running or there may be arisk of a fatal
accident!
Note
Do not touch new bulbs with your bare
fingers.
Use a clean, dry cloth to install.
If touching bulb cannot be avoided, re-
move finger prints before use.
K 1100 LT
Renewing front turn-signal bulb
Work sequence
Perform removal/installation work from the
top. (Reach through between storage com-
partment, instrument cluster and handlebar.)
@ Place motorcycle on centre stand.
@ Turn handlebar to left or right.
e@ Release the bulb holder by turning itto the
left, and pull it out.
e Press the bulb (2) in and turn it to the left
to release it. Take the bulb out.
e@ Insert the new bulb (2) into the holder,
press in and turn to the right to secure
@ Insert the bulb holder in its catch again
and secure by turning it to the right.
K 1100 RS
Renewing front turn-signal bulb
Tools required
Screwdriver with reversible blade
Work sequence
Place motorcycle on centre stand.
Take out the retaining screw (1).
Take off the flasher cover (2).
Press the bulb in and turn it to the left to
release it. Take the bulb out.
Insert the new bulb into the holder, press
in and turn to the right to secure.
@ Insert the flasher unit and screw it on
firmly.