Daikin GTKC48UV16W Operation Manual page 12

Operation
LED/ 7 SEGMENT BRIGHTNESS Control Operation
The brightness of the indicator lamp/ 7 Segment can be adjusted H(high), L(low), or OFF.
To set the brightness setting mode.
Press(<:�swlNoJ
■ for more than 5 second's.
L d
•
is displayed on the LCD.
8will
■ Press show the last memory setting of brightness intensity of indicator lamp/ 7 Segment.
8
■ Again Press to adjust the brightness to the indicator lamp / 7 Segment.
rH"Ld1.
■ ( c�swi,ojfor
Press about or more than 5 second's again to exit from the brightness setting mode or when the
remote controller is left untouched for 60 second's, it returns to the normal mode automatically.
DEW CLEAN Operation
This Function helps to clean accumulation of Dust & Stain on indoor Heat Exchanger.
■ To use
DEW CLEAN
below steps.
�
■ Press for more than 2 second's and release the button then
DEW CLEAN
times and then it disappears.
■ The indicator lamp (green and orange) on the Indoor Unit will blink together during the operation.
LED
■ The operation stops automatically as per below defined process and unit will switched OFF after completion.
Once press
Dew Clean
button
To cancel DEW CLEAN operation
-Turn OFF the machine from Remote Controller /Wi-Fi Control
NOTE
■
Note on LED/ 7 Segment Brightness Control :
• "Ld" indicates for the brightness }Light} feature which is appeared on set temperature area.
• Remote will be in High Brightness Intensity by default whenever batteries inserted.
• Keep this in mind that If user sets LED lights to be in "OFF" state }using Brightness control feature} and if Power failure
occurs then when power will resume LED will remain in OFF state }needs to reset LED Brightness Control again}
■
Note on DEW CLEAN operation :
During DEW CLEAN operation, except Streamer other functions of Remote
Automatically controls temperature and airflow rate, so manual adjustment of these function is unavailable.
If Mains Power Reset or Power failure occur, Dew Clean Operation
User is recommended to avoid staying inside the room during Dew Clean operation as Indoor temperature will be lower.
If room temperature is lower than minimum remote temperature setting then this function will not work.
Recommended temperature range to operate this function is more than 24' C.
Recommended to use this function once in a month to get better cooling effect.
Do not keep LED lights in " OFF" state (using Brightness control feature) before starting Dew Clean Operation, otherwise
light not blink during the operation making it difficult to identify the Dew Clean mode.
will
This function is available in both COOL and DRY Mode of operation.
11
, td 1�1
-1 [
operation, Remote Controller and Machine should be in
9
About 65 minutes
Dew Cleaning mode
{Cooling operation)
'e "
About 30 minutes
{Unit will
Dry mode
not work.
will
stop.
will
operation and follow the
ON
blinks on the remote
LCD
End
Appprox. 95 minutes
(1 hours 35 minutes)
OFF)
4