Daikin GTKC48UV16W Operation Manual page 11

0
t'
I
Checking the Inverter Output and Temperature Display
• When "Good Sleep/Display" key of remote controller push down and hold it for � 2 second then
"DISPLAY" IR Signal will be transmitted.
• The inverter output and temperature display for the indoor unit shows the current inverter output,
indoor temperature, and set temperature.
■
Checking current inverter output, indoor temperature and set temperature when
air conditioner is in operation
GOOD SLEEP/
1. Press [O/iii) for � 2 seconds during operation
DISPLAY
• Each press of
output, indoor temperature, and set temperature.
No display (Default)
• Inverter output service as an estimate of power consumption.(where rated power
consumption is 100%}
• There is a" . "(dot) after the set temperature figure.
• Inverter output does not display when the unit is in FAN operation.
• Set temperature does not display when the unit is in DRY operation or FAN
operation.
• Inverter output and set temperature may not display depending on the operation
mode that is active.
• The display turns off when the unit is turned off.
■
Checking current indoor temperature when the air conditioner is off
1
1. Press"foi�1 when the air conditioner is OFF and remote is ON.
DISPLAY
• The current indoor temperature displays.
• Press the button again to turn off the display.
NOTE
■ Note on the Inverter output and temperature display
"F.L."
• displays as inverter output when the rated power consumption is exceeded.
• " • • "may display for a short while after the air conditioner is turned on or at other
times.
• Inverter output may be low at times for the purposes of protecting the product.
• When the unit is operated using another device, such as a wired remote controller or
smartphone, the set temperature displayed may not match the set temperature on the
remote controller.
• An error code will display if the air condttioner fails to operate when turned on. Consult
your service centre. Refer to the error code table in
GOOD SLEEP/
l�f!l
for � 2 seconds, Cycles the display through current inverter
Inverter output
"Troubleshooting".
Indoor temperature
anllJ
Set temperature
10