Robot Coupe R 101 Operating Instructions Manual page 8

A
WARNING
CLEANING •
BLADE
After cleaning the blade, always dry the blades well.
As a precaution, always unplug your ap-
pliance before cleaning it (risk of electrocution).
• MOTOR BASE
Never immerse the motor base in water. Clean
using a damp cloth or sponge.
• BOWL CUTTER ATTACHMENT
After removing the lid, remove the bowl from
the motor base by rotating it to the left. Pull up to
disengage, leaving the blade in the bowl in order to
prevent any spillage when working with liquids.
If the food has a solid consistency, remove the blade
and empty the bowl.
Replace the bowl, place the blade back on the shaft
and switch on the machine in order to remove any
mixture which may have stuck to the blade.
If you wish, you can rinse the bowl by filling it with
hot water and switching on for a few minutes.
• VEGETABLE PREPARATION ATTACHMENT
After removing the lid, by rotating to the left, pull
out the disk by raising it by the edges, then pull out
the bowl by rotating in a clockwise direction.
Next clean all the parts.
Whatever the attachment, we recommend that you
clean it by hand using washing-up liquid rather
than in a machine. This will help your machine to
last longer.
8
A
IMPORTANT
Check that your detergent is suitable for
cleaning plastic parts. Some washing agents
are too alkaline [e.g. high levels of caustic
soda or ammonia) and totally incompatible
with certain types of plastic, causing them to
deteriorate rapidly.
• MOTOR SEAL
The gasket on the motor shaft should be lubricated
regularly using a food safe lubricant.
In order to keep the motor completely watertight, it
is advisable to check the gasket regularly for wear
and tear and replace if necessary.
The gasket can be easily replaced without having to
remove the motor, so we strongly advise you to
ensure that it is in good running order.
•WEIGHT
R 101 complete
(with 2 discs)
MAINTENANCE
TECHNICAL
SPECIFICATIONS
Net weight
7kg
Gross weight
• DIMENSIONS (in mm)
A 280
C 296
• WORKING HEIGHT
We recommend that you position the food processor
on a stable worktop so that the upper edge of the
large feed hopper is at a height of between 1.20 m
and 1.30 m.
• NOISE LEVEL
The equivalent continuous sound level when the
food processor is operating on no-load is less than
70 dB (A).
• ELECTRICAL DATA
Single phase machine
8,2kg
Motor
Speed Power
Intensity
R&pm
(Watts)
Amp.
230 V/ 50Hz
1500 450 3
115V/60Hz
1800 450 6
220V
I
60 Hz 1800 450
3