Recommended Hydraulic-Electrical Connections - Gastrodomus AV8C Installation, Operating And Maintenance Manual

RECOMMENDED HYDRAULIC-ELECTRICAL CONNECTIONS

H
K L
B = Resin container cylinder
C = Valve for softening
D = Regenerant pick-up hose
E = Regenerant container (brine)
F = Discharge hose
G = Open siphon discharge sump
ELECTRIC CONNECTIONS:

Ensure the electric power supply plug, which the valve transformer is connected to, is not controlled by an
upstream main switch. For the correct function, the valve must be constantly powered.

For the correct and safe installation of the softener, it is essential to set-up a specific plug near the appliance so
that it is easily reachable, if required.

Do not attempt any direct intervention or repair but contact professionally qualified staff. If the power supply
cable is damaged, switch-off the appliance and contact only professionally qualified staff for its replacement.
All listed devices must be conform to the relative national standards in force; the manufacturer is not to be
considered responsible for plants that are not correctly executed and non-compliance with the standards.
cod.W010771-rev.1
J
O
N
M
N
C
N
F
B
G
I = Treated water outlet (softened)
J = By-Pass piping
K = Pressure reducer (necessary for
pressures above 7bar)
L = Check valve
M = Draw-off tap for analysis
Fig. 1
Pag. 14
:
N
I
L
P
M
D
E
05/06/2021