Outlet Water Hardness Mixing / Bypass - Gastrodomus AV8C Installation, Operating And Maintenance Manual

With automatic regeneration

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Softeners with chrono-volumetric regeneration

ELECTRICAL

CONNECTION

MIXER

BYPASS

INLET WATER ¾"

OUTLET WATER ¾"

POSITIONING:

•

Ensure the entire water supply system and discharge system have been completed and cleaned from any

working residues inside the piping (debris can seriously damage the appliance). We recommend installing a pre-filter

upstream of the appliance.

•

Foresee the installation of a pressure reducer on the water inlet piping in the event the network pressure

exceeds 5bar (excessive pressures can break the entire apparatus).

•

Foresee the installation of a check valve downstream of the appliance to prevent returns and back pressures (it

is essential in the event of supplying a boiler, as a hot water return from the same, would jeopardise the entire

apparatus).

•

Foresee the installation of a by-pass connecting the valve input and output, that is useful in the event of

appliance maintenance interventions. The by-pass in diverter position, supplies the full plant with not softened water, but

will guarantee its use during the maintenance period.

•

The water connections must be made with flexible piping and the seals between the fittings or reductions (if

necessary) with Teflon® only. Do not apply excessive fastening torques to avoid any damages to the valve components.

•

The discharge fitting of the valve and any too full fitting of the brine vat, must be equipped with flexible hoses to

be positioned in the discharge basins at a lower level to the same fittings. Ensure that the hoses are not bent, obstructed

or choked. In addition, discharge must happen directly with open siphon.