Kärcher Chariot CV 60/1 RS Manual page 57

Code Description of Code
The battery is dead and will
82 need to be charged. Transport
mode is still allowed.
Side Broom Motor PWM is
being limited by unspecified
83
source.
All modes are still allowed.
Side Broom Motor Limited.
The controller is driving but a
power-limiting condition is
84
active.
All modes are still allowed.
Side Broom Motor Tempera-
ture High. PWM limiting within
range of High Motor Tempera-
85
ture.
All modes are still allowed.
Side Broom Motor ANIN Limit.
Motor temperature is above
86 software limit. Throttle input
range is being affected. All
modes are still allowed.
Brush Motor PWM is being
87 limited by unspecified source.
All modes are still allowed.
Brush Motor Limited. The
controller is driving but a
88 power-limiting condition is
active. All modes are still
allowed.
Brush Motor Temperature
High. PWM limiting within
89 range of High Motor Tempera-
ture. All modes are still
allowed.
Brush Motor ANIN Limit. Motor
temperature is above software
8A limit. Throttle input range is
being affected. All modes are
still allowed.
Traction Motor PWM is being
8B limited by unspecified source.
All modes are still allowed.
8.644-716.0 Manual Operator Chariot CV60/1 RS
Corrective Actions –
If the problem persists, call for service
Transport the machine to a charging location, key the machine off
and charge the battery.
For lithium only, ensure that the blue battery light located in the left
hand door is solid while charging. If the light is blinking or off
continue to press the button until it remains solid.
Disconnect power with the main breaker, remove the side broom
and clean
Disconnect power with the main breaker, remove the side broom
and clean
Disconnect power with the main breaker, remove the side broom
and clean
Disconnect power with the main breaker, remove the side broom
and clean.
Disconnect power with the main breaker, remove the brush tray
and clean the brushes.
Disconnect power with the main breaker, remove the brush tray
and clean the brushes.
Disconnect power with the main breaker, remove the brush tray
and clean the brushes.
Disconnect power with the main breaker, remove the brush tray
and clean the brushes.
Ensure the grade is appropriate.
Maintenance
57