Error Codes Table - Kärcher Chariot CV 60/1 RS Manual

Maintenance

Error Codes Table

Code Description of Code
01 Brush Motor Overheat
02
03 Brush Motor Short
04 Brush Motor Low FET Error
05 Brush Motor High FET Error
Brush Motor Internal Motor Controller
06
Brush Motor Unknown Motor Controller
07
Brush Motor External Temperature
08
0A Side Broom Motor Overcurrent
0B Side Broom Motor Open Circuit
0C Side Broom Motor Short
0D Side Broom Motor Low FET Error
0E Side Broom Motor High FET Error
Side Broom Motor Internal Motor
0F
Side Broom Motor Unknown Motor
10
12 Brake Manually Released
13
14 Drive Motor Low FET Error
15 Drive Motor High FET Error
Drive Motor Internal Motor Controller
16
50
Brush Motor
Overcurrent
Error
Error
Sensor Error
Controller Error
Controller Error
Drive Motor Short
Error
8.644-716.0 Manual Operator Chariot CV60/1 RS
Corrective Actions –
If the problem persists, call for service
Disconnect power with the main breaker, remove the brush
tray and clean the brushes.
Allow the motor to cool down for 1 hour before continuing
operation.
Disconnect power with the main breaker, remove the brush
tray and clean the brushes.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Disconnect power with the main breaker, remove the side
broom and clean.
Locate the side broom circuit breaker and reset.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Position the machine on a 0% grade, or chalk the wheels.
Locate the break release lever and pull down.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Disconnect power with the main breaker, remove the brush
tray and clean the brushes.
Allow the motor to cool down for 1 hour before continuing
operation.