Amino Kamai 7X User Manual

Kamai 7X User Guide
Contents
Your Kamai 7X is supplied with the correct power
adapter for your region. Depending on the choices
made by your service provider, your box may also
contain the optional accessories shown below.
The Kamai 7X is protected with a clear plastic film.
This should be removed before use.
Optional accessories
HDMI cable
Ethernet cable
3.5 mm jack to
3 x RCA cable
Remote control and batteries
1. Connecting the Kamai 7X to a TV
Warning! Before connecting or disconnecting the
Kamai 7X to your TV using any kind of cable, first switch
off the Kamai 7X, the TV and all other devices (A/V
amplifier etc.) and disconnect them from the mains
electrical supply.
You have a choice of ways to connect the audio and
video produced by the Kamai 7X to your TV:
1. HDMI: Recommended for best quality. Connect a
HDMI cable from the HDMI output of Kamai 7X to the
HDMI input of your TV.
2. Analog A/V: Provides good quality in SD only.
Composite video with analog audio left/right. Connect
the 3.5mm jack to the A/V OUT port on the Kamai 7X
and connect the yellow RCA plug to the yellow video
port on your TV. Connect the red and white RCA plugs
to the red and white audio ports on your TV.
Connecting your television directly to the audio/video
output of your Set Top Box will assure a more vivid
picture and enhance your viewing enjoyment.
Connecting to a Wi-Fi
The Kamai 7X may be supplied with internal single
or dual band Wi-Fi connectivity. If your Kamai 7X
has Wi-Fi connectivity, please contact your service
provider for detailed instructions on wireless network
configuration.
Overview of the Kamai 7X
Power/Activity LED:
Blue = on.
Blue flashing = infra-red (IR) command received /
Kamai 7X starting up.
Red = standby.
Wi-Fi signal strength indicator (only present on units
with Wi-Fi support).
1 2 3 4 5 6
1. RF antenna or cable input (optional).
2. Analogue A/V output.
3. S/PDIF optical output.
4. HDMI output.
5. USB port.
6. Reset button. Only for use under guidance from your
service provider.
7. Ethernet port.
8. DC power input 12 V 1 A, or 12 V 2 A for Wi-Fi units.
2. Connecting the Kamai 7X to an A/V
amplifier
Connect one end of an optical S/PDIF cable to the S/
PDIF optical output of the Kamai 7X. Connect the other
end of the cable to the S/PDIF optical input of your A/V
amplifier or home cinema system.
3. Connecting the Kamai 7X to power supply
Warning! The Kamai 7X must only be used with the
power adapter provided with the product. Ensure you
have the right power adapter for your region. If you are
unsure, contact your service provider.
Connect the power adapter to the DC power input of
the Kamai 7X, then insert the power adapter plug into
the mains supply.
7 8