Amino Amulet 7XM User Manual

Amulet 7XM User Guide
Contents
Your Amulet 7XM is supplied with the correct power
adapter for your region. Depending on the choices
made by your service provider, your box may also
contain the optional accessories shown below.
The Amulet 7XM is protected with a clear plastic film.
This should be removed before use.
Optional accessories
HDMI cable
Ethernet cable
3.5 mm jack to
3 x RCA cable
Remote control and batteries
1. Connecting the Amulet 7XM to a TV
Warning! Before connecting or disconnecting the Amulet 7XM to
your TV using any kind of cable, frist switch off the Amulet 7XM, the
TV and all other devices (A/V amplifier etc.) and disconnect them
from the mains electrical supply.
You have a choice of ways to connect the audio and video produced
by the Amulet 7XM to your TV:
1. HDMI: Recommended for best quality. Connect an HDMI cable
from the HDMI output of the Amulet 7XM to the HDMI input of
your TV.
2. Analog A/V: Provides good quality in SD only. Composite video
with analog audio left/right. Connect the 3.5mm jack to the A/V
out port on the Amulet 7XM and connect the yellow RCA plug to
the yellow video port on your TV. Connect the red and white RCA
plugs to the red and white audio ports on your TV.
Connecting your television directly to the audio/video output of
your Set Top Box will assure a more vivid picture and enhance your
viewing enjoyment.
Connecting to a Network
Select from one of the following networking options.
Option 1
Connect an Ethernet cable from the Amulet 7XM to a cable/DSL
modem or Network Router.
(Routers/modems are not included with the Amulet 7XM. A cable may
be included if this option has been selected by your service provider.)
Option 2
Connect one end of a coaxial cable to the MoCA cable input on
your Amulet 7XM and connect the other end to the MoCA Network
port on your modem or MoCA adapter. Please contact your service
provider for further details.
(Coaxial cables are not included with the Amulet 7XM.)
Overview of the Amulet 7XM
Power/Activity LED:
Blue = on.
Blue flashing = infra-red (IR) command received /
Amulet 7XM starting up.
Red = standby.
1
1. MoCA ("Multimedia over Coax") cable input.
2. Ethernet port.
3. Analog A/V output.
4. S/PDIF optical output.
5. HDMI output.
6. USB port.
7. DC power input 12 V 2 A.
8. Reset button. Only for use under guidance from
your service provider.
2. Connecting the Amulet 7XM to an A/V
amplifier
Connect an optical S/PDIF cable to the S/PDIF optical
output of Amulet 7XM and to the S/PDIF optical input of
your A/V amplifier or home cinema system.
3. Connecting the Amulet 7XM to power
supply
Warning! The Amulet 7XM must only be used with the
supplied power adapter.
Connect the power adapter to the DC power input
of Amulet 7XM, then connect the power adapter to
the mains supply. The power adapter provided will be
specific to your region. Ensure you have the correct
power adapter for your region. If you are unsure,
contact your service provider.
2 3 4 5 6 7 8