RACCEWAY e-city 21 User Manual page 9

BATTERY
CHARGE THE BATTERY FOR 6-8 HOURS BEFORE USING YOUR ELECTRIC SCOOTER FOR
THE FIRST TIME, BUT DO NOT UNDER ANY CIRCUMSTANCES EXCEED 12 HOURS.
Keeping your battery properly charged will help extend its life. Do not use the electric scooter if
the power indicator on the instrument panel shows a low battery level. There is a 72V battery in
the electric scooter. To recharge the battery, connect the three-pin plug to the charging socket
located directly under the front seat. During charging, the battery must be installed in the
electric scooter. If you notice anything unusual about the battery, such as a cracked or leaking
battery cover, overheating during use or charging, the battery appears swollen or bulging, etc.,
or if there are other problems with the battery, please contact an authorized service center .
The battery is sealed and not user serviceable. Do not attempt to repair, remove, modify or in
any way alter any internal or electrical components, controls or cables without first contacting
a customer service representative.
The main battery weighs approximately 42 kg. Only remove the battery from the electric
scooter if you want to replace it. Be careful when removing the battery. The electric scooter is
equipped with a 72V charger that stops the charging process as soon as the battery is
sufficiently charged. We strongly recommend that the charger is not used for more than 12
hours to avoid unnecessary wear and tear on the battery or the charger itself. Charging longer
than 12 hours can reduce the overall life and efficiency of both the battery itself and the
charger.
AVOID ANY DROPPING OF THE BATTERY
AND A WARNING. ONLY USE THE CHARGER SUPPLIED
WITH YOUR ELECTRIC SCOOTER TO AVOID DAMAGE TO THE BATTERY.
1. WARNINGfATTENTION! CHARGE AND STORE THE ELECTRIC SCOOTER
MORE THAN 6 m FROM ANY HEAT SOURCE.
2. Use only the charger supplied with the product. Make sure it is
plug inserted into a grounded outlet.
3. Connect the power cord to the socket located under the front of the seat. See picture.
4. Connect the 72V charger to a 220V AC source.
5. The charger indicator will light up indicating that power is connected to the charger. If the
light does not come on, check all connections. If, after checking all connections and fuses, the
power supply still does not work, disconnect the charger and contact an authorized service
center.
6
AND DO NOT UNDER ANY CIRCUMSTANCES LET THE BATTERY CHARGE FOR MORE THAN 12
HOURS. THE BATTERY OR CHARGER COULD OVERHEAT AND CAUSE A FIRE.
7. When the light on the charger is red, the battery is charging. When the battery is fully
charged, the green light will turn on. If this does not happen after 12 hours of charging,
disconnect the charger and contact
8