3.5 Display Interface
3.5.1 HDMI
The 96Boards specification calls for an HDMI port to be present on the board.
The Renesas RZ/G2L&RZ/V2L doesn't include a built-in HDMI interface. The Renesas RZ/G2L&RZ/V2L deploys the
built-in MIPI-DSI 4 lanes interface as the source for the HDMI output. A peripheral DSI to HDMI Bridge (U25, Analog
Devices ADV7533) performs this task and it supports a resolution from 480i to 1080p at 30Hz. While the ADV7533
supports automatic input video format timing detection (CEA-861E), an I2C channel from the Renesas RZ/G2L&RZ/V2L
allows the user to configure the operation of this bridge. It is RIIC1_I2C interface from the SoC that connects to the
bridge.
This bridge supports audio as well (meeting the 96Boards requirements to provide audio via HDMI). The Renesas
RZ/G2L100&RZ/V2L100 uses a single bit I2S1 interface from the RZ/G2L&RZ/V2L for this task.
Please note that the 96Boards specification calls for a MIPI-DSI interface to be routed to the High Speed Expansion
connector. Since the RZ/G2L&RZ/V2L has only one MIPI-DSI interface. A muxing device (U24, FSA644UCX) is being use
on the board. Only one interface, HDMI, or the Expansion MIPI-DSI can be active at a given time. The controlling signal
is named
'P4_1_DSI_SW_SEL'. When this signal is logic low, '0', the MIPI-DSI is routed to the High Speed Expansion connector.
When
'P4_1_DSI_SW_SEL' is logic level high, '1', the MIPI-DSI is routed to the DSI-HDMI Bridge. This design
assigned the 'P4_1_DSI_SW_SEL' function to P4_1/SCIF2_RXD/MTIOC7B.
3.5.2 MIPI-DSI
The 96Boards specification calls for a MIPI-DSI implementation via the High Speed Expansion Connector.
Renesas RZ/G2L&RZ/V2L implemented a four-lane MIPI_DSI interface meeting this requirement. More information about
The
this implementation can be found High speed expansion connector.
3.6 Camera Support
Renesas RZ/G2L&RZ/V2L
standard.
Room 02-04, 10/F, Block A, Building 8, Shenzhen International Innovation Valley, Dashi Road,
Nanshan District, Shenzhen, Guangdong, China
supports one 4-lane CSI1 port which used to connect high speed expansion connector as per 96boards
5